Carving Jobs
Clock Carving
A base carving was required for a wall clock. It had to match the top carving but needed to be a little smaller. It was a very intricate piece made from Cuban mahogany and it took quite some time.
Piece cut and shaped - ready for carving
One side done!
Side 2 in progress
Job done
Desk Carving
A carving was needed for a large desk- it had 3 but needed 4 so I made a new one from a nice piece of walnut.
One more needed to match remaining 3
Marked out and ready to cut
Finished and ready for polishing.
Side Table
The delicate central section of this side table was missing, so I carved a matching piece from some old Oak and fitted it in place.
Missing section
Carved and fitted into place
Carving completed. The table was missing one other small piece of carving right in the centre which the customer didn't want replacing.
Carved Shelf Support
A shelf support from an antique occasional table
Carving to top side completed...
Ready to be fitted to the table.
Carving for a Display Cabinet
I had a tricky job of carving a new shelf support from a display cabinet. The carving itself was tricky enough, but this was made more difficult as it needed to be an exact reverse of the one remaining support.
Wood cut out ready to start..
After many hours of carving!
Fixed into position on the display cabinets mirror back and polished to match
New carving on the left compared to the old existing one on the right.
